Uploading, Downloading Waypoint, Route Data - Furuno GP-30 Operator's Manual

7.10 Uploading, Downloading
Waypoint, Route Data
Waypoint and route data may be downloaded
to a PC or upload from a PC to the GP-30/
35.
Wiring
GP-35/30
IN/OUT
1 TD
2 SG
3 SD
4 RD
+
5
–
6
(Black)
7 FG
Setting for communication software
on PC
Baud Rate: 4800 bps
Character Length: 8 bit
Stop Bit: 1 bit
Parity: None
X Control: XON/XOFF
Downloading/Uploading between PC
and GP-30/35
The following data can be downloaded/up-
loaded between a personal computer and
GP-30/35.
• Waypoint data (In alphanumerical order)
• Route data ( In order of route number)
• End of sentence
Note 1: There are two kinds of data for route
data: route data and route comment data.
7-6
(Blue)
(Yellow)
(Green)
(Red)
(+)
(–)
12/24 VDC
Figure 7-13 Connection of GP-35 to PC
PC/AT
DSUB 9-pin
(EIA-574)
5 (GND)
2 (RxD)
3 (TxD)
4 (DTR)
6 (DSR)
7 (RTS)
8 (CTS)
Note 2: Data cannot be uploaded or down-
loaded when a DGPS beacon receiver is ac-
tive. To receive or transmit data, set
BEACON on the D-GPS SETUP menu to
OFF.
Note 3: DPGS position fix is not available
when uploading or downloading data.
Downloading to PC
1. Open the I/O SETUP menu.
2. Select SAVE WP/RTE
I/O SETUP
DATA1 : NMEA-REM
DATA2 : NMEA-REM
NMEA VER : VER2.0
SAVE WP/RTE
LOAD WP/RTE
IF DGPS, SET DATA2 TO BEACON.
Figure 7-14 I/O SETUP menu
PC/AT
DSUB 25-pin
(EIA-232)
7 (GND)
3 (RxD)
2 (TxD)
4 (RTS)
5 (CTS)
6 (DSR)
20 (DTR)
PC?.
PC?
PC?