Advertisement
Available languages
Available languages
Customer Responsibilities
Before
Daily
each
or after
each
use
use
[}heck Safety Valve
:}rain Tank
@
O
Risk of Unsafe
Operation,
Unit
cycmee automatically
when power
is on, When servicing,
you may
be exposed
to voltage sources,
compressed
air, or moving parts,
Before servicing
unit unplug or
disconnect
electrical
supply to
the air compressor,
bmeed tank
of pressure,
and allow the air
compressor
to cool
NOTE: See "Operation"
section for
the location of controls.
To Check
Safety
Valve
Risk of Bursting,
if the safety vamve
does not work properly,
over=
pressurization
may occur, causing
air tank rupture
or an explosion,
1.
Bdore starting compressor,
pull
the ring on the safety valve to
make sure that the safety valve
operates freely. If the vane
is stuck or does not operate
smoothly, it must be replaced
with the same type of valve.
To Drain
Tank
1.
Set the On/Auto/Off
lever to
"Off".
2.
Turn the regulator knob counter-
clockwise to set the outlet
pressure to zero.
3.
Remove the air tooi or accessory.
4.
Pull ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately
20 psi. Release safety valve ring.
5.
Drain water from air tank by
opening drain valve (counter-
clockwise.
condense
in the air tank, if not
drained,
water will corrode
and
weaken
the air tank causing
a risk
of air tank rupture,
6.
After the water has been drained,
close the drain valve (clockwise).
The air compressor can now be
stored
NOTE: If drain valve is plugged,
release alI air pressure.
The valve
can then be removed, cleaned, the
reinstalled.
15- ENG
A09705
Advertisement
