Assembly And Setup; Contents Of Carton - MTD 240 Series Operator's Manual

Assembly & Set-Up
3
Contentsof Carton
OneTiller
One Engine Operator's Manual
One 20 oz. bottle SAE 30W oil
One Tiller Operator's Manual
NOTE:The tiller is shipped without gasoline or oil in the engine.
Fill up gasoline and oil as instructed in the accompanying engine
manual before operating your machine.
Assembly
Handle
1.
Remove the handle crank, bolt, washer, retainer bracket
and the flange lock nuts from the lower handle. See
Fig. 3-1.
Washer
Bolt 1
Handle Crank
\\
,. J
Figure 3-1
2.
Position the upper handle onto the lower handle. See Fig.
3-2. Align the holes on the lower handle with the holes on
the upper handle.
Washer
Retainer
Bracket
3.
4.
Nuts
Handle Crank
Figure 3-2
Insert the handle crank through the lower hole on the
handle and secure with the nut removed in step 1. See
Fig. 3-2.
Insert the bolt and washer through the hole in the handle
and secure with the retainer bracket and then the upper
nut removed in step 1. See Fig.3-2.