Customer Responsibilities - Craftsman 358.350210 Operator's Manual

LIMBING
• Limb a tree only a fter i tiscut d own.
• Leave the larger limbs u nderneath
felled t ree tosupport tree as you work.
• Start atthe base o fthe felled t ree
and work t oward the top, c utting
branches and limbs. Remove small
limbs w ith one cut.
• Keep t ree between you and the chain.
• Remove larger branches with the
cutting techniques described in
BUCKING WITHOUT ASUPPORT.
• Always use anovercut tocut s mall
and freely h anging limbs. Undercut-
ting could c ause l imbs t ofall a nd
pinch s aw.
PRUNING
_WARNING: Limit pruning to limbs
shoulder height or below. Do not cut if
branches are higher than your shoul-
der. Get a professional to do the job.
• Make your first cut 1/3 of the way
through the bottom of the limb. This
cut will make the limb sag so that it
falls easily on the second cut.
• Next make the second cut an over-
cut all the way through the limb.
• Finish the pruning operation by using
an overcut so that the stump of the
limb protrudes 1 to 2 inches from the
trunk of the tree.
lSecond First cut
cut
1/3 of way
/_ 3rdcut 1 to2in. from trunk of tree
CUSTOMER RESPONSIBILITIES
_WARNING: Disconnect the spark plug before performing maintenance
except for carburetor adjustments=
Fill in dates as you complete
regular service
Check for damaged/worn parts
Check for loose fasteners/parts
Check chain tension
Check chain sharpness
Check guide bar
Check fuel mixture level
Check guide bar and chain oil
Inspect and clean unit & decals
Check chain brake
Clean guide bar groove
Clean air filter
Clean/inspect muffler and spark
arresting screen
Replace spark plug and fuel filter
Before After
Use Use
v,"
Ever Every
5 hrs. 25 hrs. Yearly
v"
Service
Dates
13