How To Mount The Connector Tube - Craftsman 502.249274 Owner's Manual

ASSEMBLY
HOW TO MOUNT THE CONNECTOR TUBE
Mount the connector tube with the fasteners shown full size below.
(A) (B) (C)
26x239 15x89 4x24
4x71
Q
(E)
15x66
Elbow
A
/
Align the holes.
j Decal
C
E
/
D
Rubber
Latch
Figure 10
1,
2,
3,
Assemble the handle and the rubber latch to the connector
tube with the fasteners (Figure 10). Hold screws (C) and (D)
with a short screwdriver and tighten Iocknuts (B) and (E).
Align the two holes in the connector tube with the hole on the
elbow. Slide the connector tube into the elbow until the se-
cond line on the decal is even with the edge of the elbow.
Fasten the elbow to the connector tube with screw (A). Push
screw (A) through the hole on the elbow. 3]ghten screw (A) un-
til the head of the screw touches the elbow.
Cover
Elbow
Connector Tube
Handle
Figure 11
4. Move the lift lever to the lowest position.
5,
Hold the handle on the connector tube (Figure 11). Put the
edge of the elbow in the hole of the cover. Move the connector
tube and elbow to the left until the elbow locks in place.
6. Align the rubber latch with the latch pin (Figure 12).
7. Slide the connector tube over the extension tube.
8. Lock the rubber latch to the latch pin.
Conne_or
Tube
Lock Rubber Latch
To Latch Pin
Extension Tube
Figure 12
F-95900 10