Assembly/Adjustments - Craftsman 137.218020 Operator's Manual

ASSEMBLE STAND (FIG. A)
1. Unpack all parts and group by type and size. Refer
to the parts list for correct quantities.
2. Attach one long upper support (P) to top of leg (S)
using one bolt (1) and nut (2).
NOTE: Do not tighten bolts until stand is properly
aligned (see step #8 before tightening).
3. Attach other end of long upper support to top of
another leg using one bolt and nut.
4. Attach one long bottom support (R) to center of each
leg using bolt (1) and nut (2). This completes the
front frame section.
5. Assemble rear frame section in exactly the same
manner.
6. Join front and rear frame assemblies using two short
upper supports (O) and two short bottom supports
(Q), bolts and nuts.
7. Insert foot pad (T) into bottom of leg. Repeat for
each leg.
8. Place stand on level surface and adjust so all legs
are contacting the floor and are at similar angles to
the floor, and detents in stand leg align with support
brackets, then tighten all bolts.
NOTE: Stand should not rock after all bolts are
tightened.
Fig. A
ASSEMBLE TABLE SAW TO STAND (FIG. A-l)
1. Place protective cardboard or old blanket on floor to
protect the saw table surface.
2. Place the saw up side down on the protective
material (see Fig. A-1 ).
3. Position the stand up side down on the saw base.
NOTE: Make sure front of stand and front of saw are
facing the same direction.
4. Line up the four holes in saw base and stand.
5. Fasten saw to stand using four bolts (3), washers
(4) and nuts (5).
NOTE: Place washer on each bolt before inserting
into saw base and through the support. Nut must be
immediately against the bracket (see Fig. A).
6. Carefully set the saw in its upright position on a
clean level surface.
7. Tighten all four nuts.
NOTE: DO NOT OVER TIGHTEN NUTS HOLDING
SAW TO STAND. THIS MAY DAMAGE THE SAW
BASE,
WARNING I
IF THE STAND WILL NOT BE USED, DO NOT
OPERATE THE TABLE SAW ON THE FLOOR. THIS
IS A VERY DANGEROUS POSITION.
Fig. A-1
3
o
s
10