BEVEL POINTER ADJUSTMENT
(FIG. T)
When you have achieved a 90 ° angle of the blade
to the table top as described in section above, the
angle pointer (1) may require adjustment. If so, follow
proceeding steps:
1.
Loosen pointer screw (2) and move the pointer (1)
so it is aligned with 0 ° on the bevel scale.
2.
Retighten the pointer screw.
Fig. T
1
45 ° BEVEL STOP (FIG. U)
1.
Raise the blade to maximum height by rotating the
handwheel counterclockwise.
2.
Loosen bevel angle lock knob.
3.
Tilt the blade to 45 ° bevel.
4.
Using a square (1), verify blade is 45 ° to the table
top.
5.
If blade is not 45 ° to the table, back off the
adjustment screw (2).
6.
Loosen bevel lock knob and square blade 45 ° to the
table.
7.
Once blade is at 45 ° to the table top, lock bevel
angle locking knob.
8.
Carefully tighten adjusting screw (2) until it touches
the bevel stop. DO NOT OVER TIGHTEN.
9.
Recheck to ensure blade is still aligned at 45 ° .
Fig. U