Table of Contents
Advertisement
(6) Start the server and write the EDID data.
When the <N> key is pressed
Erasing Composite Flags
Composite Sync Signals are not supported by KVM Switches. If EDID data of a composite
monitor is sent to a server, the server may output a Composite Sync Signal.
To prevent a Composite Sync Signal from being output, perform the procedures in "9.4.3 Plug
and Play Data (EDID Data) Settings" to automatically convert EDID data and to disable the
Composite Sync Signal.
The EDID data can also not be converted by following the procedure below.
(1) Enter MODE-1 of the Hotkey mode.
(2) Press <N> or the right button of the mouse to enter the Customer mode.
(3) Move the cursor to DEFAULT MONITOR (default setting) and press <ENTER> and
<SHIFT> or press <SHIFT> and the central mouse button at the same time. When
either of these actions is performed, "SCANNING" is displayed, the KVM Switch
reads the EDID data from the monitor that is connected to the [CONSOLE] port and
sets the EDID data.
When the <P> key is pressed
MONITOR TYPE: EDID setting mode
VER.: The current F/W version
2 6
Advertisement
Table of Contents
