Page 2
[ CAUTION ] This product and related documents are the copyright of Fujitsu Component Ltd. Any unauthorized reprinting, copying, republishing, or modification of this product or document is prohibited by law. The details of this product and document are subject to revision without notice.
1. Introduction Thank you for purchasing SERVIS EX (from here on, "the device" or "the switch device"). This computer-switching device (KVM switch) is PC/AT (from here on, "PC") compatible. Using just one monitor, keyboard and mouse, this device allows you to operate several PC’s.
If it is not connected properly, it may cause trouble. Cascading can only be performed with Fujitsu KVM switches only. You cannot cascade with switches produced by other manufacturers.
The following PS/2 mice are supported: 2/3 button mice, all types of wheel mice (Microsoft IntelliMouse, Microsoft IntelliMouse Explorer, Logitech/Logicool MouseMan Wheel+, etc.) and Fujitsu FID677 (Multi-scroll mouse). *Special kinds of mice, which need dedicated drivers, are not supported. PS/2 keyboards are supported.
It blinks when in the Hot Key mode or being reset. d. [RESET] Switch Use this switch when PC selection is not possible, when the keyboard or mouse cannot be operated, or when the monitor setting data also needs to be saved. The [SELECT] LED's blink and PCs can be restored without being rebooted.
Rear Panel f. Connectors for PC Ports [1 through 4] Connect each port (1 through 4) on this device to the PC's keyboard/mouse/monitor connector with the dedicated cable. g. Keyboard Connector (Keyboard Icon) Connect a PS/2 keyboard here. h. Mouse Connector (Mouse Icon) Connect the PS/2 mouse here.
(Connect (d)) (6) After confirming that the connections have been done correctly, start the first PC only. (7) After the PC's start-up, press the RESET switch once for the monitor setting data to be saved. (For details, refer to "Monitor Settings" on page 9) (8) After the setting has been done, re-start the first PC.
Page 9
(Connect (h)) (7) If the SELECT LED device lights up, press the RESET switch once for the monitor setting data to be saved. The setting data will be saved at both the master and slave sides.
Operation (Selecting PC) There are two ways to select a PC: the select switch and the Hot Key Mode. Also, when the power to the selected PC is turned off, the status is preserved. Switch to the PC you want to select using the select switch or the Hot Key Mode.
Page 11
(1) Disabling the Hot Keys While pressing the select switch "2", press the Hot Key you want to disable. Do not release the select switch before pressing the Hot Key, or the setting will not be done. Once the setting is done, the Hot Key cannot be used.
When creating cascaded connections with Fujitsu advanced model (FS-1004, FS-1008 or FS-1016), connect FS-1004EX at the slave side. (The OSD function will be effective.) Use 1.8m dedicated PS/2 cables. Also, there are function limitations, as stated below.
Refer to "Auto Scan Mode", and set correctly Check the connections and restart Press the reset switch Correct the problem at the PC Correct the problem at the PC Cascade with Fujitsu KVM switch Press the reset switch Action...