Installing The Scanner; Connecting The Cables - Fujitsu fi-6130Z Getting Started Manual

Installing the Scanner

Install the scanner in the following procedure.
1.
Place the scanner at its installation site.
Carry the scanner by supporting it
from the bottom.
fi-6130Z/fi-6140Z
Outer dimensions
Installation space
301
(11.85)
400
(15.75)
fi-6230Z/fi-6240Z
Outer dimensions
Installation space
301(11.85)
400
(15.75)
2.
Unlock the transport lock switch.
For fi-6230Z/6240Z, there is a carrier unit
inside the flatbed which is fixed in place to
prevent damage during transportation.
Slide the transport lock switch on the front.
Locked
380
(14.96)
158
(6.22)
160(6.30)
700(27.56)
Unit: mm (in.)
450
(17.72)
229
(9.02)
567(22.32)
800(31.50)
Unit: mm (in.)
Unlocked
Transport lock switch
3.
Attach the ADF paper chute.
Insert the tabs into the slots on the back of
the scanner, and tilt the ADF paper chute
backwards until it locks in place.
Tab

Connecting the Cables

Connect each cable in the following procedure.
SCSI connector
[fi-6140Z/fi-6240Z]
SCSI cable
[fi-6140Z/fi-6240Z]
CAUTION
Only use the supplied AC adapter. Not doing
so may cause the scanner to malfunction.
1.
Confirm that the computer is turned off.
2.
Connect the scanner to the computer with
a USB or SCSI cable.
SCSI connection is supported by fi-6140Z/
fi-6240Z only.
USB cable and SCSI cable cannot be
connected at the same time.
5
ADF paper chute
Side guide
2
1
SCSI ID switch
[fi-6140Z/fi-6240Z]
Power connector
AC adapter
USB connector
USB cable
AC cable