Placing The Original Document; Selecting The Correct Media Type - Epson Stylus Photo RX620 Product Information Manual

Epson Stylus Photo RX620
Envelopes
1. Open the output tray and flip the feeder guard forward (as
shown on page 5).
2. Load up to 10 envelopes at a time, short edge first, flap edge
left, and printable side up, against the right edge of the sheet
feeder, behind the tab.
Note:
Do not place the envelopes in front of the feeder guard. For best
results, press each envelope flat before loading, or load one
envelope at a time. Avoid envelopes that are too thin; they may
curl during printing.
3. Press the sides of the left edge guide together and slide it
against the envelopes (but not too tightly).
Select the following settings when printing on envelopes:
❏
as the Type (Windows) or Media Type
Plain paper
(Macintosh) setting
❏ The correct envelope size as the Size (Windows) or
Paper Size (Macintosh) setting
❏
as the Orientation setting
Landscape

Selecting the Correct Media Type

Select the paper Type (Windows) or Media Type (Macintosh)
setting according to these guidelines:
For this paper
Plain paper sheets or envelopes
Epson Iron-on Transfer paperEpson
Premium Bright White Paper
Epson Photo Quality Ink Jet Paper
Epson Photo Quality Ink Jet Cards
Epson Photo Quality Self Adhesive
Sheets
Epson Matte Paper Heavyweight
Epson Double-Sided Matte Paper
PremierArt Matte Scrapbook Photo
Paper for Epson
Epson Photo Paper
Epson Glossy Photo Paper
Epson All-Purpose Glossy Paper
Epson Glossy Photo Greeting Cards
Epson Stylus Photo RX620
6 -
Load envelopes
short edge first,
printable side up,
and flap edge left
Select this Type or
Media Type setting
Plain paper/ Bright White
Paper
Photo Quality Ink Jet Paper
Matte Paper - Heavyweight
Photo Paper
Glossy Photo Paper
11/04
For this paper
Epson Premium Glossy Photo Paper
Epson Photo Stickers
Epson Premium Luster Photo Paper
Epson Premium Semigloss Photo Paper
Epson ColorLife Photo Paper
Epson Semigloss Scrapbook Photo
Paper
Epson Ink Jet Transparencies

Placing the Original Document

Follow these steps to position a photo or document to scan or
copy:
1. Open the scanner lid.
2. Place your photo or document face-down on the glass in the
upper left corner about 1/8 inch from the edges, as shown.
Move the photo or
document in about 1/8
inch from the edges
3. Close the scanner lid.
Note:
If you place your photo or document against the edge of the
glass, the edges of your photo or document may not be copied.
To scan or copy a thick document, you can
remove the scanner lid. Turn off the RX620,
and open the scanner lid completely. Then
disconnect the cord from the TPU connector
and pull the lid straight up. Turn on the RX620
and gently press down the original to keep it
flat on the scanner glass as you scan. When
you're finished, be sure to turn off the RX620
before replacing the scanner lid and plugging
in the connector.
Select this Type or
Media Type setting
Premium Glossy Photo
Paper
Premium Luster Photo
Paper
Premium Semigloss Photo
Paper
ColorLife Photo Paper
Ink Jet Transparencies