Replacing The System Board - Lenovo ThinkServer RD630 Hardware Maintenance Manual

6. Install a new system board battery.
Figure 120. Installing the system board battery
7. If you have lifted up the riser card assembly 1, reinstall it into the chassis. See "Replacing the riser
card assembly 1" on page 137.
8. Dispose of the old system board battery as required by local ordinances or regulations.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to "Completing the parts replacement" on page 162. After you replace
the system board battery, you must reset passwords, reset system date and time, and reconfigure the
server. See Chapter 5 "Configuring the server" on page 55.

Replacing the system board

Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 71.
This topic provides instructions on how to replace the system board.
Note: This procedure must be performed only by trained service personnel of Lenovo.
CAUTION:
Hazardous moving parts. Keep fingers and other body parts away.
CAUTION:
The heat sink(s) and microprocessor(s) might be very hot. Turn off the server and wait three to five
minutes to let the server cool before removing the server cover.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
154
ThinkServer Hardware Maintenance Manual