VTech VT-1910c Instruction Manual page 9

WALL INSTALLATION USING
MOUNTING SCREWS PROVIDED
Tools You Will Need: A hammer, a
nail, a pencil or ballpoint pen, a Phillips
head (+) screwdriver, and the Wall
Mounting Template included in the
back of this booklet.
1. Choose a spot near an electrical
outlet and a telephone jack.
Your phone requires a modular
telephone jack and a standard
electrical outlet (1 20v AC). The
power cord is six feet long; make
sure there is an electrical outlet
within reach of the base. The
outlet should not be controlled by
a wall switch. If the switch is ever
turned off, the phone will not
operate.
2. Choose and mark the mounting
position.
The mounting screws should screw
into a wooden stud within the wall-
they will not hold securely in
wallboard alone. Locate a wall
stud in the area where you want to
install your telephone. Use the
Wall- Mounting Template and a
pencil to mark the screw positions
on the wall over the stud (Figure
1). Put the template aside.
3. Install the mounting sleeves and
screws.
Start the screw holes by lightly
tapping a nail into the marks you
made on the wall. Remove the nail
from the wall. Now slip the
mounting sleeves onto the screws
-
-
Figure 1
Figure 2
as shown, with the smaller end of
the sleeve toward the screw head.
lnsert the screws into the holes you
started. Tighten the screws until
the larger end of the mounting
sleeve is flat against the wall
(Figure
2).
USING THE WALL MOUNT
ADAPTOR
1. Position the wall mount bracket
on the base.
Line up the tabs on the wall mount
adaptor with the holes on the
bottom of the base (Figure
1).
Snap the wall mount bracket firmly
in place.
2.
Mount the base on the wall.
Position the base so the mounting
studs will fit into the holes on the
bottom of the base. Position the
power cord to extend down the wall
the phone is to be mounted on.
Slide the base down on the
mounting studs until it locks into
place.
3. Connect the telephone line cord.
The telephone line cord has a
snap-in plug at each end. lnsert
one of the plugs into the jack on the
bottom of the base. lnsert the other
end of the plug into the wall jack.
4. Plug the ac adaptor on the
power cord into an electrical
outlet (Figure 2).
5. Set the TONUPULSE SWITCH
on the base unit.
If you have touch tone service on
Figure 1
phone line, set the switch to
TONE. If you have rotary service,
set the switch to PULSE (Figure
3).
TONE PULSE
SELECTION
gure
3