The Handset Layout - VTech VT-1910c Instruction Manual

MEMORY DIALING:
0
-
MEMORY DIALING
1 I W I I
PRESS-
PRESS W
YOU WlLL SEE
ENTER MEMORY
LOCATION (01
-
20)
-
~
Press the
[ m ~ )
key.
Press
m.
Enter the memory location of the
numbers you wish to dial (01
...
20).
The number will be displayed on
the LCD and will be dialed.
CID
-
CALLER ID
To view information stored in CID
memory, press
(CID)
on the
handset.
The display will show the most
recent call received.
To view the time and date of the
call press and hold the 7 key.
The time and date will be shown
along with the phone number. You
will see something like:
As long as the key is held down.
To view other calls, scroll backwards
and forwards by using the
A
(*)
and
v
(*) keys.
To view additional dlgits not shown
on the display, press the
- .
(9) key
To exit press
m.
USING REDIAL
Press the
( m ~ ]
key, then
( - L ) to automatically redial
out the last number you dialed.
Press ( - L ) so that the
number is shown on the display
and then press the
( m )
key.
HOLD
press to put a call on hold.
To return to the call, press
key again
MAKING CALLS
You can make calls directly from the
handset whether you are at the base
or away from it.
NOTE: There are two different ways
to dial a number:
1.
Press the
( M )
key and wait
for dial tone. Then dial the number
you want.
2. Enter the number onto the display
first, then press the ( - E ) key.
This will dial the number that is
displayed on the LCD after 2
seconds. See "ADVANCED
DIALING" on Page 22
If you make a mistake when dialing,
press to hang up, then press
the PHONE key to get the dial tone
again.
DISCONNECTING
To end a call, either place the handset
back in the base, or press on
the handset.
OFF MODE (STANDBY)
When the unit is OFF the display will
be clear.
VOLUME CONTROLS
The handset has a digital volume
control.
The volume controls for the handset
are located on the side of the unit.
Press the
A
(up) or
v
(down) keys
to increase of decrease the volume.
Holding either key down will
continuously change thevolume setting.
The ear piece volume level indicator
will change accordingly.
FLASH
You can use your Vtech VT 1910c
cordless phone with services such as
Call Waiting. Instead of pressing the
switch-hook (as you would on a regular
phone) press the ( - E ] key.
REDIAL
To REDIAL the last number you dialed,
[ ) k e y , then press
phone will automatically
dial the number. The number will be
shown on the display.
CLEARING THE DISPLAY
The display can be cleared by pressing
and holding the CLEAWDEL key down
until the display clears.
MUTE
Press on the handset
to disable the handset microphone.
Press again to return to
normal operation.
RINGER MUTE
Press
( K q
on the handset
during incoming ringing will disable
the ringer for the duration of the
call.