Table of Contents
Advertisement
Error Messages
The MR-HD100 will display error messages on its LCD display if
certain conditions occur that can effect MR-HD100 operation. Below
is a list of the error messages and the actions to take:
Error Message Description
LOW BATTERY!
HIGH
TEMPERATURE!
NO SPACE LEFT!
DISK ERROR
XXX
NO DISK
DETECTED
WRONG
PRODUCT ID
FILE NOT FOUND
AUDIO MUTE
Data CRC Errors
CRC (Cyclic Redundancy Check) errors indicate that either a file is
corrupted (this might be a hardware error) or a file system is
corrupted.
CRC's are caused by any of the following:
• Computer hard drive
• Computer hard drive copying the files
• Computer port
• Computer file system corruption
• Cable, FireWire or USB MR-HD100 hard drive
• MR-HD100 port
• MR-HD100 file system corruption
Battery power is low.
The unit is getting too hot for
normal operation.
The Disk Drive is Full.
Lost Disk Communication.
Lost Disk Communication.
Incorrect Software Loaded.
Wrong filename or missing file. Check filename or that upgrade file
Record or Playback with VF
mode set to 24, 25 or 30 is
muted for the PN NFR formats
(QuickTime PN and P2 PN).
Technical Specifications
Action
Connect AC Power or replace the battery
pack.
Check ambient air temperature. Is unit in
direct sun light or near heat source?
Transfer files off the drive and format it
before attempting to do more recording.
Contact Focus Enhancements Technical
Support.
Contact Focus Enhancements Technical
Support.
Download correct software and perform
upgrade again.
exists.
This is normal. No action is required.
MR-HD100 Media Recorder
187
Advertisement
Table of Contents
