MR-HD100 with Other Devices
MR-HD100 to Wired (Ethernet) Network
This procedure requires the use of a USB 2.0 to Ethernet Extender.
1. With the MR-HD100 powered off, use an USB 2.0 to
Ethernet Extender to connect the MR-HD100 to the network.
2. Power on the MR-HD100 and wait for the Home screen to
appear.
3. Go to the
If the network employs DCHP, the
IP MASK
assigned addresses.
4. Open an IE or Safari web browser.
5. Enter the MR-HD100's
address bar and enter.
The MR-HD100
MR-HD100 and FTP
To access the MR-HD100 via FTP, follow the same steps above.
In Step 5, enter the address
from SETUP.
For more information about FTP password, see
page 115.
MR-HD100 Media Recorder
144
menu and locate
SETUP
,
, and
BROADCAST
IP ADDR
Templates
ftp://FS:FS@
IP ADDR
SETUP
display the network
GATEWAY
into the browser's IP
web page opens.
and then the
.
options
IP ADDR
IP ADDR
on
FTP PASS
,