Lexmark MX6500e 6500e Setup Manual page 11

IPDS Printer and Host Setup Guide iSeries and AS/400 LAN Printing Using the Printer Standard Network Port or MarkNet Internal Print Server
Example CRTDEVPRT with parameters to change shown in
Remote network identifier............. RMTNETID
Workstation customizing object........ WSCST
Library............................
Authority............................. AUT
Note 1: Setting the
the same printer. The writer does not time out while waiting on the printer to start a new job.
Step 4 Configure the Printer's Print Server TCP/IP Settings
To enable IPDS printing with a Standard Network port or a MarkNet internal LAN print server, several settings
must be verified. You can verify these settings from the printer control panel as shown below.
1 From a Ready state press the MENU button (printers). Touch
2 Use the navigation buttons
3 Select Network/Ports.
TIp: To do this on printers, press the Select button
4 Now you will see a list of menus. Select the Standard Network menu.
5 Select Std Network Setup.
6 Select TCP/IP.
7 Use the navigation buttons or icons to scroll through the options. Check each of the following settings and
change them as needed to configure TCP/IP communication.
TCP/IP Settings
Parameter
Activate
(Printers: Must
cations. MFPs: not displayed.)
IP Address
(Address available from your network administrator)
Netmask
(Appropriate netmask for your network)
Gateway
(IP address of your IP gateway)
Enable DHCP
(On, if you use a DHCP server.)
(Off, if you set the IP address another way.)
Activation Timer
or icon
Value
On
be "On" to enable TCP/IP communi-
157.184.67.102
255.255.255.0
157.184.67.1
On or Off
*NOMAX
to allows multiple writers or multiple hosts to use
to scroll to Network/Ports.
; on touch screens touch Network/Ports.
bold.
*NETATR
*NONE
*LIBCRTAUT
or on touch screens.
11