Connector #2 - CompuSTAR CM3000 Manual To Installation

Connector #2:

Pin #1: Green/White- This is the low voltage (-) parking light output
200mA. Some newer vehicles require a (-) parking light output instead of
the standard (+) output (reference connector #1) such as the new Jeeps
and even some Fords.
Pin #2: Black- This is the (-) Status Out wire. It provides you with a (-)
200mA output as soon as the remote start is activated. This is the
sequence:
1. Remote Start unit receives signal to activate
2. At that time the Status becomes active providing the (-) 200mA
trigger
3. The ignition will activate and the car will start.
This is the wire you would connect to a Transponder Module or maybe a
VATS module.
Pin #3: Green- This wire is the (-) 2
connect this wire to the purple pigtail of the additional relay on CN #1.
This will result in a (+) trigger output for the 2
of the same relay.
Pin #4: White/Black- This wire is the (-) 2
You may connect this wire to the purple pigtail of the additional relay on
CN #1. This will result in a (+) trigger output for the 2
blue wire of the same relay.
Pin #5: Red/Black- This wire is a (-) 2
Normally the only vehicle this would be used on Nissan' s and older
Ford' s. You may connect this wire to the purple pigtail of the additional
relay on CN #1. This will result in a (+) trigger output for the 2
on the blue wire of the same relay.
Firstech, LLC. Technical Data (CM3000)
nd
3
ignition 200mA output. You may
ignition on the blue wire
nd
Accessory 200mA output.
nd
nd
Starter 200mA output.
nd
accessory on the
starter
nd