Buffing And Polishing - Craftsman 146.107190 Owner's Manual

APPLYING WAX/POLISH TO SURFACE (See Figure 8)
IMPORTANT: Read, understand and follow all safety and user instructions
in this manual and all directions and warnings on polishes and waxes.
1. Apply paste wax / liquid polish in a straight line with either a side-to-side
or back-and-forth motion.
2. Apply past¢ wax / liquid polish in a thin, even coat. Too much does not
add any more protection and only makes the removal more difficult.
3. The random orbit motion of the buffer provides applicatien that can not be
duplicated, not even "by hand".
4. Do not use excessive pressure, let the tool do the work.
5. It is easiest to apply the wax / liquid polish to the entire surface before
starting the removal phase, however, follow the specific recommendations
of the wax or polish being used.
BUFFING AND POLISHING - REMOVING THE WAX FROM
THE SURFACE (See Figure 9)
1. Polish and remove the wax / liquid polish when it has dried to even haze.
2. Wash out and dry your Dura Foam
TM
pad. Then "Buff and Polish" the entire
surface until all dried wax is removed.
3. For the ultimate "Showroom Shine", use a 6-in. foam pad with terry cloth
bonnet (sold separately) for final buffing and polishing.
NOTE: When removing wax and polishing, it may be necessary to remove
the pad or bonnet from time to time and shake out the dried wax residue
and/or wash it. A pad or bonnet with excess residue will cause streaking.
9