Table of Contents
Advertisement
ASSEMBLY
MOUNTING TO TRACTOR (See Fig. 5)
Use Hardware - - GROUP "D"
NOTE: FOR EASE OF ASSEMBLY, YOU MAY WISH TO
OBTAIN THE ASSISTANCE OF ANOTHER PERSON FOR
MOUNTING ASSEMBLY TO TRACTOR.
Raise seat ontractorto allowassemblytobe mounted.
Withcoverclosed,liftassemblyand place supportpost
inside mountingbracket. Allow assembly to rest 0n
lancedtabs ofmountingbracket.
Lineup holesin mountingbracketwithholesin support
postand insertbrecketsupportpin.Securewithretainer
spring.
Unlatchand opencover.
Install the three (3) tubing end caps onto container
support.
Tap each end capontocontainersupporttubesto seat
securely.
BRACKET
SUPPORT PIN
..-'"'"'"--
COVER ASSEMBLY
i
,
RETAINER
i
:
SPRING
MOUNTING
BRACKET
CONTAINER ASSEMBLY (See Fig. 6)
No hardware required
Place bottomhalf insideof top haft, as shown.
Placeone footinsidebottomhalfand lifttophalftomeet
bottomhalf.
Press halvestightlytogetherwhilelifting top tolockinto
place as shown_
IMPORTANT:
BEFORE LOCKING THE TABS, HOOKED
EDGES ON BOTH HALVES MUST OVERLAP TO FORM
SEAL AS SHOWN IN INSET.
Repeat for second container.
CONTAINER
BOTTOM
HALF
CONTAINER
TOP HALF
CONTAINER
BOTTOM
HALF
PRESS TOGETHER
TO FORMSEAL
WHILE UFTING
TOP HALF
LOCKING
TAB
ASSEMBLY
CHECK: Squeeze sides of lower half of con-
tainer and check that there is no gap between upper and
lower halves.
If a gap appears, unlock tabs tO separate
container halves and repeat instructions above.
Fig. 6
Fig. 5
8
Advertisement
Table of Contents
