Craftsman 917.249121 Owner's Manual page 7

ASSEMBLY
1
MOWER DECK BAFFLE (See Fig. 1)
Use Hardware - - GROUP "A"
Raise yourtractormowerdeck to itshighestposition.
Installthe hex bolt, and Iocknutthrough mower deck
baffle and tightensecurely.
MOWER DECK BAFFLE
HEX BOLT
Fig. 1
REAR MOUNTING BRACKET
(See Fig, 2)
Use Hardware - - GROUP "B"
Assemblethe mountingbracket,lancedtabs towards
bottom,usingthe fourholeson the drawbar.
NOTE: START THE SELFTAPPING BOLTS INTOHOLES
ON THE DRAWBARAT LEASTTWO FULL TURNS AND
REMOVE. THIS WILL MAKE IT MUCH EASIER TO FAS-
TEN THE BOLTSONCETHE MOUNTING BRACKET IS IN
PLACE.
install the tour bolts as shownand tighten securely.
BOLT
(SELF TAPPING)
LANCED TABS TOWARD BOTTOM
COVER SEAL (See Fig. 3)
No hardware required
AIk_nmark on seal with mark at cover opening.
Work sealintoopening so cover sitsbetween flangesof
seal.
AUGNMENT
MARKS
COVER SEAL
Fig. 3
suPPORT POST (See Fig. 4)
Use Hardware - - GROUP "C"
CAUTION: Corttalner support Is spring ]
leaded and lockedto the cover. Handle
cover assembly carefully so as not to
unlatch the cover _om the container
support.
Rotate cover assemblyonto its side as shown.
Assemble supportpost to containersupportwith the
three (3) hexbolts and Iocknuts.T ghten securey.
HEXBOL_
SUPPORT
POST
I
LOCKNUTS
Fig. 4
Fig. 2
7