Assembly; Contents Of Shipping Carton; Tools Required For Assembly - Craftsman 536.885910 Owner's Manual

,, ,,, LI i i
MBLY
i ii i H i, ,,, , •
THIS SNOW THROWER IS EQUIPPED WITH "TRAC-PLUS" AND ONLY
MOVES EFFECTIVELY WHEN ENGINE IS RUNNING
i
ff yoursnow thrower must be moved withoutthe aid of theengine, it willbe easier to pull the snowthrower back-
ward by the handles, ratherthan pushing.
On startUp,the track drive system may be tight and wni loosen up as the _ow thrower is used. Alter first use,
checkthe track for tension and adjust if necessary. See the Track Adjustmentparagraph in the Service and Adjust-
mentssectionof this manual. Check track adjustment and fasteners regularly.
CONTE_S OF SHIPPING CARTON r,' TOOLS REQUIRED FOR ASSEMBLY
1-
PartsShown Below:
1 - Snow thrower completely assembled except for
the crank assembly, shifter lever assembly and
knob, andrthe upper handle, whichis in the folded
down position.
Parts Bag Containing:
Owner'sManual (Not Shown)
ElectdcStarter Cord 9.5 Ft (not shown)
1 - Knife (to cut cartonand plastiaties)
2 - 1/2 inchWrenches (or adjustablewrenches)
2- 9!16 inch Wrenches (or adjustablewrenches)
2- 3/4 inchWrenches (or adjustablewrenches)
1. Pair Pliers (to spread cotter pin)
1- ScreWdriver
2 - 3/8 in. Flatwashers
"2- 1t4-20x 1 _3!,$ In.
Hex Head Boit_
1-3/8 In. Lockwasher
CONTENTS OF PARTSBAG
ii , i |
*2 - Spare Spacers
II
1 - Knob WithThreads
©
1-3/8 In. Hex Nut
1-3/8 - 16x2 In. Hex Head Bolt
*2 - Spare 1/4 - 20 Locknuts
2 - Cablelies
>
*Non-Assembled Parts
6