Assembly & Set-Up - Craftsman C459-52537 Operator's Manual

Assembly & Set-Up
IMPORTANT: The snow thrower is shipped with oil and WITHOUT
GASOLINE. After assembly, refer to separate engine manual for
proper fuel and engine oil recommendations.
NOTE: Remove all loose parts and any packing material before
assembling.
NOTE: References to right or left side of the snow thrower are
determined from behind the unit in the operating position.
NOTE: This Operator's Manual covers several models, handle
panels, lights and chute cranks are some features that may vary
by model. Not all features referenced (or engines pictured) in
this manual are applicable to all snow thrower models.
Assembly
Handle
1. Place the shift lever in the Forward-6 position.
2. Observe the lower rear area of the snow thrower to be sure
both cables are aligned with roller guides before pivoting
the handle upward. See Figure 3-1.
Figure 3-1
NOTE: Make certain the cables are seated properly in the
roller guides. See Figure 3-2.
Figure 3-2
3. Secure the handle by tightening the plastic knob located
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
3
7