Excell XR2625 Operation Manual page 12

attempt to change nozzles while
pressure washer is running. Turn
engine off before changing nozzles.
1. Press turret release button to
release turret.
2. Rotate turret to chosen nozzle.
3. Push turret onto nozzle and lock
into place.
Spray Pattern
Uses
Surfaces *
*
washer is capable of causing damage to surfaces such as wood, glass,
automobile paint, auto striping and trim, and delicate objects such as
fl owers and shrubs. Before spraying, check the item to be cleaned to
assure yourself that it is strong enough to resist damage from the force
of the spray.
HOW TO APPLY CHEMICALS
AND CLEANING SOLVENTS
Applying chemicals or cleaning
solvents is a low pressure operation.
NOTE: Use only soaps and chemicals
designed for pressure washer use. Do
not use bleach.
To Apply chemicals:
1. Make sure the
chemical hose
is pressed
onto the
barbed fi tting
located near
high pressure
hose
connection of pump as shown.
A14687
Risk of fl uid
injection. Do Not
0º
powerful
pinpoint for
very intense
cleaning
Metal or
concrete
DO NOT use
on wood
The high pressure spray from your pressure
Barbed
Fitting
15º
intense intense
cleaning of cleaning of
small areas larger areas
metal, metal,
concrete, or concrete, or
wood wood
2. Place other end of chemical
hose with fi lter on it into container
holding chemical/cleaning
solution. NOTE: For every 7
gallons of water pumped 1 gallon
of chemical/cleaning solution will
be used.
3. Select the soap nozzle on the gatling
spray wand, see o Use Spray Wand
paragraph in this section.
4. After use of chemicals, place
chemical hose into container of
clean water and draw clean water
through chemical injection system
to rinse system thoroughly. If
chemicals remain in the pump
it could be damaged. Pumps
damaged due to chemicals will
not be covered under warranty.
12- ENG
40º Soap
applies
cleaning
solutions
metal,
concrete,
wood, or vinyl