Above Floor Cleaning - Bissell AeroSwift™ Compact Vacuum User Manual

Operations
5 height adjustments
Turn the height adjustment dial on the front of
the power foot to match your cleaning needs.
The graphics around the dial indicate the
appropriate setting for cleaning bare floor to
high pile carpet. Turn the dial to the center for
medium pile carpet.
notE: If difficult to push, adjust to highest
setting.

above floor cleaning

long Reach cleaning
ideal for cleaning areas with 5- to 10-foot
required reach.
1. in upright position, lift the Quick Release lever
on the back of the vacuum to slide the Quick
Release Handle out of the base.
2. Remove the hose from the hose wand base
and connect to the open inlet at the handle.
3. Connect desired tool to the end of the wand
for cleaning different above floor surfaces.
a. Extension Wand: connect with a desired
tool for a farther reach.
b. Crevice Tool: use in tight, narrow spaces.
c. TurboBrush® Tool: use air-driven power
brush to clean areas such as stairs, furniture,
and other areas too small to clean in floor
cleaning mode.
d. Combo Dusting/Upholstery Brush: use
dusting brush to clean delicate surfaces;
slide dusting brush off to clean upholstery
and other hard surfaces.
Short Reach cleaning
ideal for cleaning areas with below 5-foot
required reach.
4. in upright position remove the hose from the
hose wand base.
5. Attached desired tool to the end of the hose.
notIcE:
The brush will continue to rotate at the same
speed at all settings.
notIcE:
Refer to maintenance section if you observe
a loss in suction performance while in floor
cleaning mode.
www.bissell.com
1.
3a.
3c.
4.
2.
3b.
3d.
5.
800.237.7691
7