Bissell AeroSwift™ Compact Vacuum User Manual page 11

Maintenance & Care
check Rotating floor brush
1. Unplug the vacuum from electrical outlet.
2. Recline the handle into lowest position and
turn the vacuum over so bottom side is facing
up. Remove dirt bin to avoid any damage to the
bin and easier access to the floor brush.
3. Remove the 3 screws in the brush cover using
a Phillips screwdriver. lift up and remove the
brush cover to access brush roll.
4. Grasp the rotating brush at both ends at
lift out.
5. Clear strings, hair and other debris from
the brush, brush cover, motor pulley and drive
belt areas.
6. Check the drive belt for wear, cuts or stressed
areas. if you see no visible damage, keep the belt
connected to motor pulley. if belt is damaged,
refer to replace drive belt section.
7. With drive belt connected to motor pulley, pull
the belt over the brush roll and position the floor
brush into the brush cover ends. Rotate the brush
end opposite of the belt to line up with the brush
cover tab. The brush end closest to the belt will
slide in the tab without needing to rotate.
8. Replace brush cover and secure with the
3 screws.
WaRnInG
To reduce the risk of injury from moving parts, turn
off vacuum cleaner and disconnect Power Plug from
electrical outlet.
3.
5.
www.bissell.com
4.
7.
800.237.7691
11