Lenovo ThinkServer RD430 User Manual page 57

Use the following instructions to connect cables from the expander card to the backplanes for 2.5-inch
hard disk drives:
1. For hard disk drive 0 to hard disk drive 3, use a mini-SAS to mini-SAS signal cable and connect the
mini-SAS connector
the mini-SAS connector on the other end of the cable to the mini-SAS ports 0-3 on the backplane
for 2.5-inch hard disk drives in the middle cage.
2. For hard disk drive 4 to hard disk drive 7, use a mini-SAS to mini-SAS signal cable and connect the
mini-SAS connector
the mini-SAS connector on the other end of the cable to the mini-SAS ports 4-7 on the backplane
for 2.5-inch hard disk drives in the middle cage.
3. For hard disk drive 8 to hard disk drive 11, use a mini-SAS to mini-SAS signal cable and connect the
mini-SAS connector
the mini-SAS connector on the other end of the cable to the mini-SAS ports 0-3 on the backplane
for 2.5-inch hard disk drives in the right cage.
4. If your server has more than 12 hard disk drives installed, for hard disk drive 12 to hard disk drive 15,
use a mini-SAS to mini-SAS signal cable and connect the mini-SAS connector
cable to the connector 6 on the expander card. Then, connect the mini-SAS connector on the other end
of the cable to the mini-SAS ports 4-7 on the backplane for 2.5-inch hard disk drives in the right cage.
Figure 35. Connecting cables from the expander card to the backplanes for 2.5-inch hard disk drives
Refer to the following topics for information about the connector locations and the power cable connections:
• "Hot-swap hard disk drive backplane" on page 38
• "Expander card" on page 37
• "System board components" on page 47
1
on one end of the cable to the connector 3 on the expander card. Then, connect
2 on one end of the cable to the connector 4 on the expander card. Then, connect
3 on one end of the cable to the connector 5 on the expander card. Then, connect
4 on one end of the
.
Chapter 3 Product overview
45