Table of Contents
Advertisement
CONNECT
BATTERY
(See Figs. 2 and 3)
LY
ii
i ill
•
i i iiiiii
II_L
j,,lll
CAUTION: Do not short battery termi-
nals.
Before connecting battery, re-.
move metal
bracelets,
wristwatch
bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding.
•
Remove cardboard packing from seat pan and lift seat
pan to raised position.
.
Open battery box door'.
•
Remove terminal protective caps and discard.
•
if this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for' minimum of one hour at 6d 0 ampso
°
First connect RED battery cable to positive (+) terminal
with hex bolt, flat washer, lock washer and hex nut as
shown. Tighten securely.
°
Connect BLACK grounding cable to negative (-) termi-
nal with remaining hex bolt, flat washer, lock washer
and hex nut. Tighten securely,.
Close battery box door_
SEAT
PAN
BATTERY
BOXDOOR
FIG. 3
INSTALL SEAT (See Fig. 4)
Adjust seat before tightening adjustment boil
•
Remove cardboard packing on seat pan.
Open battery box door for:
=
Inspection for secure connections (to tlghten hard-
ware)°
°
inspection for corrosion,,
*
Testing battery,.
.
Jumping (if required),,
.
Periodic charging.
DISCARD
TERMINAL
POSITIVE
PROTECTIVE
(RED) CABLE
CAPS
LOCK
HEX
WASHER
NUT
FLAT
NEGATIVE
(BLACK) CABLE
HEX
BOLT
o
Place seat on pan and assemble shoulder bolt.
•
Assemble adjustment bolt, lockwasher and flat washer
Ioosely_ Do not tighten.
°
Tighten shoulder bolt securely,,
°
Lower seat into operating position and sit on seat,
°
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way down
(See Fig_8)_
•
Get off seat without moving its adjusted position.
°
Raise seat and tighten adjustment bolt securely.
SEAT
SEAT PAN
SHOULDER
BOLT X
ADJUSTMENT
BOLT
FIG. 4
FLAT WASHER
LOCK WASHER
FIG. 2
8
Advertisement
Table of Contents
