Table of Contents
Advertisement
AND ADJUSTMENTS
TO REPLACE HEADLIGHT
BULB
°
Raise hood.
•
Pull bulb holder out of the ho]e in the backside of the
griJL
•
Replace bulb in holder and push bulb holder' securely
back into the hole in the backside of the grill.
°
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
°
Check wiringo See electrical wiringdiagram in Repair
Parts section of this manual.
TO REPLACE
FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash_
TO REMOVE
HOOD
AND
GRILL
ASSEMBLY
(See Fig. 26)
°
Raise hood.
°
Unsnap headlight wire connector..
°
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor_
-
To replace, reverse above procedure.
HOOD
HEADLIGHT
WIRE
CONNECTOR
ENGINE
TO ADJUST
THROTTLE
CONTROL
CABLE
(See Fig. 27)
The throttle control has been preset at the factory and
adjustment shouldnot be necessary. Check adjustment as
described below before loosening cable, if adjustment is
necessary, proceed as follows:
°
With engine not running, move throttle control lever
from slow (-e_) to choke (N) position_ Slowly move
lever from choke (N) to fast (,te_)position.
°
Check that holes"A" in governor control lever and hole
in governor plate line-up. If holes "A" are not aligned,
loosen clamp screw and move throttle cable until holes
are aligned,. Tighten clamp screw securely_
GOVERNOR
GOVERNOR
CONTROL LEVER
CONTROL PLATE
\
HOLES "A"
CLAMP
THROTTLE
SCREW
CABLE
FIG. 27
FIG. 26
24
Advertisement
Table of Contents
