Table of Contents
Advertisement
BATTERY
Your tractor has a battery charging system which is suffi-
cient for normal use. However, periodic charging of the
battery with an automotive charger wilt extend its life.
,
Keep battery and terminals clean.
•
Keep battery bolts tight_
o
Keep sma!_vent holes open°
•
Recharge at 6-10 amperes for I hour._
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and terminals can cause
the battery to "leak" power.
°
Open battery box door°
°
Disconnect BLACK battery cable first then RED bat-
tery cable and remove battery from tractor.
o
Rinse the battery with plain water and dry.
-
Clean terminals and battery cable ends with wire brash
until bright°
°
Coat terminals with grease or petroleum jelly.
,
Reinstall battery (See "CONNECT BATTERY" in the
Assembly section of this manual).
V-BELTS
Check V-belts for deterioration and wear after 100 hoursof
operation and replace if necessary. The belts are not
adjustable° Replace belts if they begin to slip from wear.
TRANSAXLE
COOLING
Keep transaxle free from buitd-up of dirt and chaff which
can restrict cooling..
ENGINE
LUBRICATION
Only use high quality detergent oil rated with API service
classification SF or SG. Select the oil's SAEviscosity grade
according to your expected operating temperature.
SAE VISCOSITYGRADES
-30"
-20_
*_0_
O'
10'
20'
00'
400
TEMPERATURE
RANGE ANTICIPATED
BEFORE NF..XTOIL CHANGE
NOTE: Although multi-viscosity oils (5W30, 10W30 etc.)
improve starting in cold weather, these multi-viscosity oils
will result in increased oil consumption when used above
32°F, Check your engine oil level more frequently to avoid
possible engine damage from running tow on oil.
Change the oil after the first two hours of operation and
every 25 hours thereafter or at least once a year if the
tractor is not used for 25 hours in one year.
Check the crankcase oil level before starting the engine
and after each eight (8) hours of operation_ Tighten oil fill
cap/dipstick securely each time you check the oil level.
TO CHANGE ENGINE OIL (See Figs. 11 and 12)
Determine temperature range expected before oil change.
All oi! must meet API service classification SF or SG..
•
Be sure tractor is on level surface°
•
Oil will drain more freely when warm
•
Catch oil in a suitable container.
•
Remove oil fill cap/dipstick. Be careful not to allow dirt
to enter the engine when changing oil.
•
Remove drain plug.
•
After oil has drained completely, replace oil drain plug
and tighten securely_
•
Refill engine with oil through oil fill dipstick tube. Pour
slowly. Do not overfill. For approximate capacity see
'PRODUCT SPECIFICATIONS
on page 3 of this
manual.
•
Use gauge on oil fill cap/dipstick for checking tevel. Be
sure dipstick cap is tightened securely for accurate
reading. Keep oil at "FULL" line on dipstick.
OIL FILL
CAP/DIPSTICK
OIL DRAIN
PLUG
FIG. 12
FIG, 11
17
Advertisement
Table of Contents
