Table of Contents
Advertisement
| Installing the Plate Guide on the Printer
14
Tighten the screws (first #1 and then #2 as shown) with the two hexagonal wrenches, making sure the
4.
fixing pin on the right of the plate guide fits tightly against the black plastic cover component.
Note:
The hexagonal wrench included with the Epson Stylus Pro 7900CTP system and the one included with the
printer are different sizes. You need both sizes.
Aligning the Plate Guide
The plate guide must be correctly aligned to remove any skew when printing on the plate. Otherwise, you
will have registration problems on the press.
Close the printer's roll paper cover.
1.
Make sure the fixing pin firmly touches the black plastic cover component. If it is not secure, loosen
2.
the nut, extend the pin, and then tighten the nut.
Insert a test plate and print the file "7900CTP_alignment_sheet.pdf" that is included on the CD or
3.
downloaded from www.proimaging.epson.com. (See "Loading a Plate in the Printer" on page 19.)
The included EFI RIP has a menu option that prints this file automatically.
Note:
You must use an Epson DirectPlate Aluminum plate (12
accurate.
Fixing pin
Nut
#1
Tighten screw #1
then screw #2
#2
×
18 inches) for this test because paper won't be
Advertisement
Table of Contents
