Table of Contents
Advertisement
Wireless remote controller kit
Owner's Manual
3
CORRECT
USAGE
• Auto ®, Heat -_, Dry 6,
Cool ®, Fan x
Power
Turn on the power supply switch 12 hours
before starting operation.
* The remote controller is disabled for approx.
1 minute after the indoor unit has been
powered on. This is normal. (The signal from
the remote controller is received, but the
receive data is discarded.)
1
Push
I(_ (ON/OFF
button).
2
Push
_
(Mode
button)
to select
an
operation
mode.
•
Select Auto, Heat, Dry, Cool, or Fan.
3
Push
R
(Fan speed
button)
to select
a fan speed.
•
When the Auto mode is selected, the fan
speed changes automatically.
The fan
speed does not change automatically
in
the Fan mode.
4
Push either
@ or @ to select
the
desired
temperature.
•
Temperature setting is not available for the
Fan speed.
5
Stop
Push d,D (ON/OFF button).
When the operation is stopped with the
remote controller, the outdoor unit fan keeps
running in some cases even after the
compressor
of the outdoor unit has stopped.
• If the room is notwell heatedwith
FAN
B
during heating, change the fan
speed to FAN XJ_ or FAN XJ.
Although selected fan speed is displayed,
some indoor unit types are not provided
with the air volume change function. (Fan
speed is constant.)
• If the unit operation cannot be stopped
in the usual manner, turn off the circuit
breaker and contact the dealer from
whom you purchased the air
conditioner,
• Automatic
Cooling/Heating
When all indoor units in the same refrigerant
system are under the group control, heating
or cooling operation is automatically
performed according to the difference
between the setup temperature and the
room temperature.
7-EN
- 7 -
Advertisement
Table of Contents
