Correct Usage - Toshiba TCB-AX21UL Owner's Manual

Wireless remote controller kit
3

CORRECT USAGE

Cool/Heat AUTO
Dry , Cool
Power supply
Turn on the power supply switch 12 hours
before starting the operation.
• After the power supply has been turned
on, the operation of the remote controller
is not accepted for approx. 1 minute. It is
not a failure.
(The sensor receives the signal once, but
the received contents are cleared.)
2
3
1
Push (ON/OFF button).
2
Push (Mode button)
operation to select one of
and .
3
Push (Fan Speed button) to select
one of fan speed modes.
When selecting
automatically changed.
(During FAN mode, the air speed is not
automatically changed.)
4
Push either
desired temperature.
During FAN mode, the temperature cannot be
set up.
5
Stop
Push ON/OFF button.
When using the remote controller to stop the
unit, the outdoor unit fan may keep operating
for a while even if the compressor of the
outdoor unit has stopped.
9-EN
, Heat
, Fan
1
4
, , ,
, the fan speed is
or to select the
,
• In heating operation, if the room is not
comfortably heated with FAN
select FAN
Although they are displayed, the function
may not be provided according to the used
indoor unit. (Fan speed is constant.)
• When the unit cannot be stopped by
the normal operation
Turn off the circuit breaker, and then
contact the shop which you purchased the
unit.
Automatic cool/heat
When all indoor units in the identical
refrigerant system are controlled as a group,
the cooling/heating operation is
automatically performed with the difference
between the setup temperature and the
room temperature.
Dry operation
,
• There is no dry function according to the
used indoor unit even if DRY is displayed
on the display section of the remote
controller. (Same to Cooling operation)
• When the room temperature approaches
the setup temperature, running/stop
operations are automatically repeated.
• In order not to return humidity to the room
as possible, the mode of indoor fan enters
LOW mode when the operation has
stopped.
• The fan speed cannot be adjusted
according to the used indoor unit or status
of the room temperature.
• The DRY mode cannot be used according
to the used indoor unit when the outdoor
temperature is 59°F (15°C) or lower.
– 9 –
Owner's Manual
,
or .