Correct - Toshiba Carrier TCB-AX21UL Owner's Manual

Wireless remote controller kit Owner's Manual
3
CORRECT USAGE
• Cool/Heat AUTO ®, Heat "_.'-,
Dry 6, Cool _, Fan X
Power supply
Turn on the power supply switch 12 hours
before starting the operation.
• After the power supply has been turned
on, the operation of the remote controller
is not accepted for approx. 1 minute. It is
not a failure.
(The sensor receives the signal once, but
the received contents are cleared.)
1
Push _ (ON/OFF button).
2
Push [] (Mode button)
operation to select one of _, _, 0 , _,
and B.
3
Push X (Fan Speed button) to select
one of fan speed modes.
When selecting _, the fan speed is
automatically changed.
(During FAN mode, the air speed is not
automatically changed.)
4
Push either _ or _v_ to select the
desired temperature.
During FAN mode, the temperature cannot be
set up.
5 Stop
Push ON/OFF button.
When using the remote controller to stop the
unit, the outdoor unit fan may keep operating
for a while even if the compressor of the
outdoor unit has stopped.
• In heating operation, if the room is not
comfortably heated with FAN X ,
select FAN XJ_ or HI.
Although they are displayed, the function
may not be provided according to the used
indoor unit. (Fan speed is constant.)
• When the unit cannot be stopped by
the normal operation
Turn off the circuit breaker, and then
contact the shop which you purchased the
unit.
• Automatic cool/heat
When all indoor units in the identical
refrigerant system are controlled as a group,
the cooling/heating operation is
automatically performed with the difference
between the setup temperature and the
room temperature.
• Dry operation
• There is no dry function according to the
used indoor unit even if DRY is displayed
on the display section of the remote
controller. (Same to Cooling operation)
• When the room temperature approaches
the setup temperature, running/stop
operations are automatically repeated.
• In order not to return humidity to the room
as possible, the mode of indoor fan enters
LOW mode when the operation has
stopped.
• The fan speed cannot be adjusted
according to the used indoor unit or status
of the room temperature.
• The DRY mode cannot be used according
to the used indoor unit when the outdoor
temperature is 59°F (15°C) or lower.
9-EN -
9
-