Table of Contents
Advertisement
Wireless remote controller kit
Owner's Manual
8
HOW TO HANDLE THE REMOTE
CONTROLLER
• Point the transmitting unit of the remote controller at the signal receiving unit of the indoor
unit. When a signal is received normally, "pi" sound is heard once. ("Pi, pi" is heard only at
the beginning of operation.)
• The standard signal receivable distance from the signal receiving unit of the indoor unit is
approx. 23' (7 m). The distance varies somewhat with the battery capacity or other
conditions.
• Do not put anything that blocks signals between the remote controller and the signal
receiving unit of the indoor unit.
• Do not put the remote controller at a place exposed to direct sunlight or air from the indoor
unit or near a heater.
• Do not drop or throw the remote controller or wipe it with water.
• Signals from the remote controller may not be accepted in a room equipped with a rapid
start-type or inverter-type fluorescent light. For details, contact the dealer from whom you
purchased the air conditioner.
• To set the Remote Controller
on the Wall
• Push _
at the installation position on the wall to check that the signal from the remote
controller is received correctly.
• To take the remote controller out of the holder, pull it toward you.
Fix the remote controller
holder with screws.
Mounting screw
Truss tapping
J
f
Remote controller
holder
Setting the remote
controller into the holder
Put on.
@
Push
-12-
Advertisement
Table of Contents
