Table of Contents
Advertisement
Operating the Dishwasher
Selecting
the Proper Wash Cycle
items with baked-on
or hard, dried-on
soiling will
require either
Power Scrub Plus or possibly
soaking
and hand-scouring.
The Regular
Wash cycle will thoroughly
clean
large loads having loosely attached
normal
soiling.
Use this cycle for most soil loads.
Using the Auto Wash cycle will take the guess
work out of cycle selection!
The sensors
in the
dishwasher
automatically
adjust the cycle length,
temperature
and water changes
based on the
soil load.
To avoid
damage
to delicate
or heirloom
items do not wash them
in your dishwasher.
For delicate
or heirloom
dishware
and silverware,
or other special
items, select
Quick Wash after
referring
to the Materials
section
of this manual.
Hand-washing
may be the best treatment
of such
items.
More information
on dishwasher
cycles is in the
Wash Cycle information
section
of this manual.
Starting
the Dishwasher
Shut the dishwasher
door.
Press the On/Off
button.
Press the button for the desired
wash cycle.
The dishwasher
will start automatically
and
continue
operating
until the end of the selected
cycle.
Once you start the dishwasher,
leave the
dishwasher
door shut until it finishes
the cycle.
Interrupting
a Cycle
NOTE: Should you need to interrupt
a cycle (to
add or remove an item, to add detergent,
etc.), it
is best to do so within the first 30 minutes
of the
cycle.
Press the On/Off
button.
You could be seriously
scalded
if you open
the dishwasher
door
quickly
during a wash
or rinse cycle. Do not fully
open the
I dishwasher
door for at least
10 seconds
or
[until
water
noises
stop.
12
Wait at least ten seconds
or until water noises
stop before opening
the dishwasher
door.
To resume the cycle, shut the dishwasher
door
and press the On/Off
button.
Canceling
or Changing
a Cycle
To cancel or change
a cycle, press and hold for
three seconds
the two buttons
labeled "Cancel
Drain" as shown in Figure 23.
Figure 23
Wait approximately
one minute, then press the
On/Off
button
You may now begin a new cycle.
Child
Safety
Latch
Your dishwasher
is shipped
from the factory with
the Child Safety Latch disengaged
and in the
normal
operating
mode. Pull on the door handle to
open the door. The Child Safety
latch activation
lever is located
in the recess for the door handle.
You must look up into the recess to find the Child
Safety
Latch activation
lever (see Figure 24).
To activate the Child Safety Latch insert a
matchstick
or other non-metal
object into the
opening
as shown in Figure 24. The activation
lever will release
and move toward the left.
You have now activated
the Child Safety Latch.
Each time you open the dishwasher
door you will
need to slide the activation
lever to the right
to release the door locking mechanism,
you can
then pull the door open (See Figure 25). After you
open the door you should release
the Child Safety
Latch Activation
lever and let it slide back toward
the left.
To deactivate
the Child Safety Latch insert a
matchstick
or other non-metal
object into the
opening
as shown in Figure 26. Slide the
activation
level to the right and hold. Remove
the
matchstick
and release the lever. The feature
has
now been deactivated
and you can open the door
by pulling the handle.
Advertisement
Table of Contents
