Input Source Selection (Component, Scart , Hdmi) - Sanyo PLC-WL2503A Owner's Manual

Video Input

Input Source Selection (Component, Scart , HDMI)

Direct Operation
Choose Computer 1(Component) or Computer 1(Scart)
by pressing the the COMPONENT or COMPUTER 1 button
on the remote control or press the INPUT button on the top
control; choose HDMI by pressing the HDMI button on the
remote control or press the INPUT button on the top control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
Top Control
INPUT button
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select Input and
then press the Point ► or the SELECT button.
2
Use the Point ▲▼ buttons to select Computer 1 and
then press the Point ► button; use the Point ▲▼
buttons to select Component or RGB(Scart) and then
press the SELECT button.
OR
Use the Point ▲▼ buttons to select HDMI, and then
press the SELECT button;
When the input source is coming from video
Component
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a
Component-VGA Cable, select Component.
When the input source is coming from video
RGB (Scart)
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
When the video signal is connected to the
HDMI
HDMI terminal, select HDMI.
Note:
When the Input Search function is set to On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.45).
38
Remote Control
Computer 1
*
the COMPUTER IN 2/ MONITOR OUT terminal
Computer 2 *
as MONITOR OUT output.
HDMI
Input Menu
Video
S-video
COMPUTER 1 button
HDMI
Computer 1 (Scart)
HDMI button
COMPONENT button
ASPECT
COMPUTER 2 can not be selected when using
Computer 1 (RGB)
HDMI
Computer 1
(Component)