Troubleshooting - Bosch Nexxt WTMC6521UC Operating, Care And Installation Instructions Manual

Loosen the screw of the cover and
open the cover.
Turn bulb counterclockwise.
Replace the bulb with a new
appliance bulb only (obtainable
through parts department).
Replace the cover and secure with
the screw.
Plug in dryer or reconnect power
supply.
Troubleshooting
TO AVOID RISK OF ELECTRICAL
SHOCK !
TO AVOID EXPLOSION HAZARD!
Repairs or replacement of parts may
be carried out by authorized
technicians only.
Before calling the customer service,
check whether you can rectify the fault
yourself by means of the following
table.
If a fault cannot be rectified or a repair
is required:
1. Set program selector to "Off".
2. Turn off the circuit breaker.
3. Pull the mains plug out of the
socket.
4. Close the shut off valve.
5. Call customer service
(see page 24).
Problem
Dryerdoesnotstart.
"Start/Stop"indicatorlightdoesnot
illuminate.
Laundryis wet after drying.
Programhas beeninterrupted.
A warningsignalis emittedand the
displayshows"E:01".
Possiblecause
Main plugnot insettedat all or not insertedcorrectly.
A fuse of powersupplyhastripped.
"StaWStop" buttonnot pressed.
No programselected.
Doornot closed.
In Time-Programs d urationnot chosen.
Ambienttemperaturebelow41 °F/5 °C.
Theshut-off valveis closed.
Lint filter dirty.
Drumlightdoesnot function.
"StaWStop" indicatorlightdoesnot
illuminate."Wrinkie block"indicator
lights.
Thedisplayshows"000".
Exhaust a ir duct is blockedor too long.
Fault in programsequence or malfunction.
The room/cabinet i s not adequately ventilated.
No programselected.
Light bulbdefective,light bulb burnedout.
No powersupply.
Light bulbis loose.
Fault in programsequence or malfunction.
Remedialaction
Insertmainplug correctly,
Replace/swkch o n fuse.
Press"Start/Stop"button.
Selectprogram.
Closedoor.
Chosetime via "Select"-Button.
Increaseroomtemperature.
Openthe shut-off valve.
Cleanfilter asdescribedon page22.
Switchoff/switchon again.
Cleanexhaustair duct. Reduce exhaustair duct to
maximumlengthas described on page8.
Switchoff/switchon again.
Switchoff dryer,leaveto cooldownfor 30 min,
switchon again.
Restartprogram.
Providean adequatesupplyof fresh air.
Switchoff/switchon again.
Selectprogram.
Changelight bulb,seepage22.
Guarantee powersupply.
Tightenlight bulb. Remove and reinstallthe coveras
directedon page22.
Switchoff dryer,leaveto cooldownfor 30 min,
switchon again.
Restartprogram.
23