Accessories - Bosch Nexxt WTMC6521UC Operating, Care And Installation Instructions Manual

TheBosch dryers mustbevented
outdoors. Toprevent build-up of
moisture a ndaccumulation oflint
indoors, aswell a sto maintain
maximum drying efficiency, itis
recommended thatthedryerisvented
outdoors.
Exhaustair outlet on the dryer
Thedryerisdelivered w ithanexhaust
airoutlet o ntherearoftheappliance.
Totakeaccount ofthespatial
requirements andanexisting e xhaust
airsystem, thefollowing c onnection
options arepossible f ortheexhaust air
outlet:
- onright s ideoftheappliance,
- ontheunderside o ftheappliance.
2 1
3
cause linttoaccumulate andaffect
dryerperformance anddryerlife.
Four-inch ( approx. 100mm)diameter
ducting should beused. U seeither
rigidmetal o rflexible metal d ucting
material. DONOTuseplastic or
non-metal ductwiththisdryer.
DONOT assemble t heductwork w ith
screws orfasteners thatextend intothe
duct.They will s erve asan
accumulation pointforlint.
Joints should besecured w ith
aluminum tape.
Alljoints should betighttoavoid leaks.
Themale endofeach ductsection
mustpointaway fromthedryer.
Whether connecting toanexisting
venting s ystem or a newventing
1- Exhaust airoutlet onthe rear o fthe system, make surethatallducting is
appliance (standard) clean andfreeoflint.
Themaximum permitted l ength forboth
2- Exhaust airoutlet onthe side (0pti0naI) rigidandflexible metal d uctisshown in
3- Exhaust airoutlet ontheunderside ofthe thetablebelow.
appliance (optional) Number of Rigid D uct Flexible Duct
Special exhaust airconnections must 90 °Turns
beobtained f romourcustomer service orElbows
foreither c onnection type(see page 0 66ft. 45ft.
11 ).
(2011 cm) (1372cm)
- Side air exhaust
- Bottom air exhaust 1 56 ft. 36 ft.
A qualified technician should change (1707 cm) (1097cm)
the exhaust air outlet to the optional 2 48 ft. 29 ft.
connection location. (1463 cm) (884cm)
Ductwork
3 39 ft. 22 ft.
(1189 cm) (671cm)
4 30ft. 16ft.
(914 cm) (488cm)
To ensure optimum performance, the
ducting system of the dryer should be
as short as possible with a minimum
number of elbows. Your dryer will work
best when the venting system has as
few air flow restrictions as possible.
Exhaust ducting which is longer than
recommended may extend drying time,
Note:
Side and bottom exhaust installations
have a 90°turn inside the dryer. To
determine maximum exhaust length,
add one 90°turn to the chart.
More than two 90 ° turns are not
recommended. For best performance,
separate all turns by at least 4 ft. of
straight duct, including distance
between last turn and exhaust hood.
Good
Better
Exhaust vent hood
The exhaust duct must end with an
approved exhaust vent hood with
swing out damper(s). DO NOT use an
exhaust vent hood with magnetic
latches.
To avoid exhaust restriction, the outlet
must be a minimum of 12 inches (30
cm) above ground level or any other
obstructing surface.
Required parts
The parts required for the exhaust air
system (elbows, lines, exhaust air
outlets) are not included in standard
delivery of the dryer.
Accessories
The parts required for the exhaust air
system can be obtained from customer
service or your local dealer. Please
follow the installation instructions
supplied with kits.
Side exhaust kit
part no. WTZ 1265
8