AMERICANA Model ABS300 Owner's Manual And Installation Instructions page 42

,O
I -
b -q
i w
h0
I I
I -i
i .
iiii_ii/!_iiiiiiiiii
iiii_ii%iiiiii
m
rd_
Before you call for service...
Troubleshooting -tips
Possible Causes
Oventemperaturetoo Oven thermostat
hot or too cold needs
adjustment.
What To Do
•
See tile Adjust the oven thermostat-Easy to do
yourself! section.
Clock and timerdo Plug on rmlge is not completely • Make sure electrical l_lug ix lllugged into a live, ln'operly
not work inserted in the electrical outlet, gr_)tmded outlet.
A fuse ha your home may be • Replace tuse or reset circuit breaker:
blown or the circuit breaker
tripped.
Oven controls improperly set.
• See the Using the clock and timer section.
Display goes blank A fuse in your home may be • Rel/lace the fuse or reset the circtfit breaker.
blown or the circuit breaker
tripped.
The dock is turned off from • See the Using the clock and timer section.
shm_g in the display.
Oven dooris crooked The door is out of position. • Because the oven door is removable, it sometimes
gets
out of l)osition during installation. To straighten the
door, I/ush (h)wu on the high
corner.
Oven makes This is the somad of the • This is normal.
clicking _oise
heating element turning
off and on during
cooking fm_ctions.
"F--anda number You have a ftmction error code. • Press the CLEAR/OFFpad. Put the oven back
or letter" flash in
into olleratiou.
the display If the function code repeats:
* Dis(ounect
all l)oweY to tile Y[luge to1" lit least 30
seconds and then reconnect power./f the traction
error code repeats, call for service.
• On sell:cleaning models, if a traction error code
al/pears during the self cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightl); from the locked position. Make sure the latch
is moved to the right as far as it will go. Press the
CLEAR/OFFpad. Allow the oven to cool fin" one hour.
Put the oven back into ol)eratiou.
Power outage Power outage or surge.
• Some models \\'ill automatically resuine their setting once
tile power is restored. On models with a clock, you must
reset tile clock. If tile oven was in use, you must reset it by
Ilressin"' _ tile CLEAR/OFFpad,
setting, tile clock
and
resetting any cooking traction.
Displayflashes Power failure.
unab!e to get the display Oven conlrol pads were not
to show "SF pressed properly.
• Reset tile clock.
• Tile
BAKEand BROIL HI/LO
pads m ust be pressed at tile
same time and held for 3 seconds.
42