Rack - Amana 10480902 Use & Care Manual

Adiustab e ftee @r cantilever heives
(some models)
Shelves can be adjusted to best match size of items
stored in freezer° These shelves are supported by
metal tracks in back of the freezer.
ao To remove "cantilever" shelves, tap upward at
back of shelf, near the metal track. See Figure 27.
This will loosen shelf hooks. Lift shelf and pull
out.
F_gu_÷ 27
b. To install, tilt shelf so that front is higher than
back.
c. Insert metal hooks at back of shelf into desired
slot in metal track on back wall of freezer. See
Figure 28.
Figure 28
,_, CAUTBON:
Apply pressure to front edge of shelf to insure
proper installation.
Ft÷ezet she f divid÷t ( me m e s)
Some models have a freezer shelf divider to
separate frozen food on top of shelf.
a. To move divider to a different location, first press
down on divider and slide fo1_vard about I" to
unhook middle wire.
b. Move divider to new position, positioning ends of
the divider base under freezer shelf wires.
c. Press down on divider and slide backward, to
hook middle wire and stabilize divider.
AdjustabBe doo buckets
and $heJves
There are two deep door buckets and one full-width
door shelf located on freezer door for convenient
storage.
a. Buckets and shelves can be removed for easy
cleaning. To remove, follow directions in steps a-c
on page 8.
Reversible freezer storage rack
(some models)
Reversible freezer storage rack may be placed on
top of or underneath freezer shelf to be used to
organize and separate frozen foods° See Figure 29.
I0
Figure 29
ao To remove storage rack, first remove food from
rack.
b. Hold each end of rack and push rack to right to
release rack slot from wire shelf.
c. Pull down if located under freezer shelf. Lift up if
located above freezer shelf.
d. To replace storage rack, position rack on top of or
underneath freezer shelf between shelf wires°
e° Center slot of rack should be positioned on top of
or underneath center wire of freezer shelf°
f. Lock into place by pushing rack to left. Re sure
round kndbs are securely in place° See Figure 30.
g. Rack should not move lef% or right.
Oth÷t F÷ tures
E)ecot ordoot
Door fronts of most refrigerators can be decorated
with panels to accent your kitchen decor. Tr_ kits
can be purchased separately from your Amana
dealer.
a. Basic V_d' trim kit attaches to door edges and can
accommodate V_" (1.6 ram) thick panels.
b. For panels that are _4" (_.4 ram) thick, an
additional trim kit is required. Ya" kit attaches to
panels and slides tongue-in-groove fashion into
_6" (1.6 ram) trim, which must be installed on
doors first.
c. Ask your Ax_ana dealer about panel availability
on special models or you may supply your own
panels.
d. Amana does n_* supply custom panels.