Setting Thesleep T Imer - Aiwa CX-NA50 Owner's Manual

To check the specified time and source
Press the TIMER button while pressing the SHIFT button. The timer-on time, the selected source name and the
duration for the timer-activated period are displayed for 4 seconds.
To cancel timer standby mode temporarily
Press the TIMER button repeatedly while pressing the SHIFT button repeatedly so that @ or @ REC disappears on
the display.
To restore the timer standby mode, press again to display _) or _) REC.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before the turning offthe power, repeat step 5 to prepare the source, and adjust the volume and tone.
NOTE
• Timer playback and timer recording will not begin unless the power is turned off.
• Connected equipment cannot be turned on and off by the built-in timer of this unit. Use an external timer.
TIMER RECORDING
Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.
Press the TIMER button twice while pressing the SHIFT button so that @ REC appears on the display, and
press the H SET button within 4 seconds. Repeat the steps shown above from step 2 and insert the tape to be
recorded into deck 2 after step 5.
SETTING THE SLEEP TIMER
N_ ...... j
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press the SLEEP button while pressing the SHIFT button.
2 Within 4 seconds, press the 44 or _ button to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5 and 240 minutes in 5-1ninute steps.