Setting Up Your Remote Control; Display - Samsung PLK435W Instruction Manual

Operation

Setting Up Your Remote Control

This TV's remote control can operate almost any VCR or cable box. After it has been set up properly, your
remote control can operate in three different modes: TV, VCR or Cable. Pressing the corresponding button
on the remote control allows you to switch between these modes, and control whichever piece of
equipment you choose.
POWER
TV VCR CABLE SET
1 2 3
4
5 6
8 9
7
+100

DISPLAY

0
PIP CH.SCAN ASPECT
SWAP STILL MENU
VOL VOL
CH
TV/VIDEO ADD ERASE MUTE
P.STD S.STD MTS SURR.
PRE-CH REW PLAY FF
SLEEP REC STOP PAUSE
P.SIZE LOCATE
PIP CH
34
Setting Up the Remote to Operate Your VCR
Turn off your VCR.
1
POWER Press the SET button on your TV's
2
remote control.
VCR
SET
Press the VCR button on your TV's
3
remote control.
NUMBER
BUTTONS
Using the number buttons on your
4
remote control, enter both digits of
the VCR code listed on page 36 of
this manual for your brand of VCR.
Make sure you enter both digits of
the code, even if the first digit is a
"0."(If more than one code listed, try
the first one.)
Press the POWER button on the
5
remote control. Your VCR should turn
on if your remote is set up correctly.
If your VCR does not turn on after set
up, repeat steps 2, 3, and 4, but try
one of the other codes listed for your
brand of VCR. If no other codes are
listed, try each VCR code, 00
through 72.