Changing The Password - Emulex 375 User Manual

E M 375 SAN S
MULEX ODEL TORAGE
U ' G
SER S UIDE

Changing the Password

The Switch Password page enables users to change the password for modifying the switch's
configuration. The same password is used to access both the Web Manager and the CLI.
Note: Until the default switch password is changed, any user with knowledge of the default password
can make changes to the switch's configuration.
To change the password:
1. Click Switch > Password.
The Switch Password page appears.
Figure 3-6: Switch Password page
2. Type the new password in the New Password text box.
Note: The password must be between 6 and 25 characters in length and is case sensitive.
3. Type the password again in the Confirm New Password text box.
4. Click Submit. If users are not logged in to the switch, a password prompt appears requesting
that the current password be entered. Enter the current password to proceed.
A message displays confirming that the password was saved and activated.
Opening a Telnet Session
Some switch operations may require advanced features currently not found in the Web Manager. These
features are available in the Command Line Interface (CLI), which can be accessed through the Web
Manager by opening a telnet session to the switch.
To open a telnet session with the switch:
1. Click Advanced Functions > Telnet Session.
A message box appears confirming the opening of a telnet session to the switch.
2. Click OK to proceed.
3. Enter the switch's password and press E
For additional information on CLI features and functionality, see the Emulex® or InSpeed™ Storage
Switch Products' CLI Reference Guide .
S
WITCH
NTER
E C
MULEX ORPORATION
P N 00041392-002 R
ART UMBER
C
HAPTER
.
. B
EV
3: S M
WITCH ANAGEMENT
27