Table of Contents
Advertisement
E
M
375 SAN S
MULEX
ODEL
TORAGE
U
'
G
SER
S
UIDE
Setting SNMP Traps
Simple Network Management Protocol (SNMP) uses traps to transmit information to SNMP-based
network administration programs. The Switch SNMP Trap Configuration page displays information on
the switch's current SNMP trap configuration.
To view the SNMP trap configuration page, click Switch > SNMP Traps.
Figure 3-4: Switch SNMP Trap Configuration page
To configure an SNMP trap:
1. Enter the Trap IP address for the device to which the trap information will be sent.
2. Enter the Trap Port number.
This value is usually set to "162" for Windows and Apple-based networks.
3. Select the State.
State
Active
Inactive
Delete
4. Click Submit.
When editing a registered IP address, delete the current IP address and create a new entry for the
revised IP address.
S
WITCH
Description
The trap sends messages to the host identified in the IP Address
selection.
The trap is not operational.
The trap will be deleted from the table once changes are saved.
E
C
MULEX
ORPORATION
P
N
00041392-002 R
ART
UMBER
C
3: S
HAPTER
WITCH
. B
EV
M
ANAGEMENT
25
Advertisement
Table of Contents
