Dacor Preference Renaissance RGC304 Use And Care Manual page 11

Cleaning the Igniters and Other Burner
Components
fragile and can crack or break:
IMPORTANT:
The igniters will not work properly
if the other burner parts or the igniters themselves
are not clean. Dirty or wet igniters may not spark at
all.
After dissembling the burners, check for any dirt or
grime deposited on the individual parts, including
the igniters.
1. Clean completely around the igniter, including
over and under the edge of the metal top and
porcelain base. A firm toothbrush is ideal for this
task. Use care while cleaning because the porce-
lain is fragile and can crack or break. Do not use
water to clean the igniters. If necessary, use a
small amount of rubbing alcohol to help dissolve
grime
Igniter
Standard
Burner Base
Igniter
@
SimmerSear
Burner Head
Base
2. Examine the burner heads. Remove anything
stuck in the holes with a straightened paper
clip, wire or needle. Be careful not to scratch or
damage the ring and head. Do not distort the
shape of the burner head holes. Since the burner
heads for the SimmerSear
TM
burners are not
removable, they must be cleaned in place.
3. Clean all the burner parts, including the burner
bases, with window cleaner or rubbing alcohol.
Use a cleaning brush with plastic bristles or a
firm tooth brush. When done, rinse the parts
well with clean water. Dry all the parts thor-
oughly before re-assembling them.
.
Reassemble the cooktop according to the burner
and grate assembly instructions on page 5.
Test the burners after reassembling them. If
the flame is uneven, be sure that all the burner
parts are properly positioned, then check for any
remaining dirt or grime on the burner parts or
igniter. If erratic clicking is still present, make
sure the igniter is completely dry. If the unit still
exhibits problems after drying, call your local
Dacor Authorized Service Agent.
Cleaning Stainless Steel Surfaces
cleaners or scrubbers on stainless steel surfaces.
•
Clean stainless steel surfaces with a mild solu-
tion of detergent and warm water. Rinse and dry
with a soft, lint-free cloth.
• You may also use Dacor Stainless Steel Cleaner
on the stainless steel surfaces. Use it according
to the directions on the package.
Cleaning the Knobs and Trim Rings
1. Turn the knobs to the off position to remove the
knobs and trim rings for cleaning or replace-
ment.
.
,
4.
Disconnect the cooktop power plug from the
electrical outlet.
Grasp each knob and pull straight up to remove.
The trim rings may be removed for cleaning if
necessary. Take note of the position of each trim
ring before removal. Grasp each trim ring and
pull straight up to remove.
Knob
.
Trim Ring
Sha_
Wash the knobs and trim rings with a solution
of warm soapy water. Dacor recommends hand
dishwashing liquid.
Continued...
9