Tools Required For Assembly; Check Battery - Craftsman 917.28001 Operator's Manual

s- ...... ,
Steering Wheel
Insert
Steering
Boot
Steering Wheel
(1) 5/16-18 x4 L J
Hex Bolt (1) Lockwasher Steering
f \ Shaft Cover
Steering Shaft Steering Wheel (1) Large Flat
Extension
Adapter Washer
(1) Rear Bumper (1) Front Bumper
(4) Screw
#10 x 0.200
(1) Shroud
(2) Key
Seat
Slope Sheet
Your new riding mower has been assembled at the factory with the exception of those parts
left unassembted for shipping purposes. To ensure safe and proper operation of your riding
mower all parts and hardware you assemble must be tightened securely. Use the correct
tools as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 1/2" wrench (1) Utility knife
(1) Tire pressure gauge
When right or left hand is mentioned in
this manual, it means when you are in the
operating position (seated behind the steer-
ing wheel).
TO REMOVE RIDING MOWER FROM
CARTON
UNPACK CARTON
1. Remove all accessible loose parts and
parts boxes from carton.
2. Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels fiat.
3. Remove packing materials from riding
mower.
4. Check for any additional loose parts or
cartons and remove.
NOTE: Only cut carton with a short blade
utility knife, a long blade or saw can 3uncture
tires on unit.
HOW TO SET UP YOUR RIDING
MOWER
CHECK BATTERY
Ensure battery is securely fastened, and that
all wires are securely connected.
*
Battery is located under the seat.
* Battery has been fully charged from the
factory, before installation.
J
J
Seat
_.' Battery