Tools Required For Assembly - Craftsman 917.98645 Operator's Manual

Mower
(2) Rear
(5) 1-3/16 Lift Link
O.D. Washers Assemblies
(1}small_-_
Retainer Springs
__ (1) Fro nt
Lift Link
(5) Large Assembly
Retainer Springs
Mower Front Wheel
(1) Shoulder Bolt
(1) Wheel
(1) 1-1/40.D.
Washer
(1) 3/8q6
Locknut
if Equipped
£ ....................... /
(1) Anti-Sway Bar
(1) 3/40.D.
Washers
(1) Small Retainer
Springs
Keys
(2) Keys
(1) Oil Drain Tube
(1) Quick Connect
Slope Sheet
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(2) 7/16" wrenches Utility knife
(1) 1/2" wrench Tire pressure gauge
(1) 3/4" wrench Pliers
(1) 3/4" socket w/drive ratchet
(1) 9/16" wrench Flashlight
When right or left hand is mentioned in this
manual, it means when you areinthe operating
position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and
parts cartons from carton.
• Cut along dotted lines on all four pan-
els of carton. Remove end panels and
lay side panels flat.
• Remove mower and packing materials.
• Check for any additional loose parts or
cartons and remove.