Anti-Tip Device - GE JGBP86 Owner's Manual & Installation Instructions

Installation Instructions
-AWARNING!
ANTI-TIP DEVICE
All ranges can tip and injury could
result.
To prevent accidental tipping of the range,
attach an approved Anti-Tip device to the
wall. (See Installing the Anti-Tip Device in
this section.) To check if the device is
installed and engaged properly, carefully
tip the range forward. The Anti-Tip device
should engage and prevent the range from
tipping over.
If you pull the range out from the wall for
may reason, make sure the Anti-Tip device
is engaged when you push the rmige back
agMnst the wall.
• For w)ur safety, never use your range flir warining
or heating tile rooln. Your oven and cooktop are
not designed to heat your kitchen. Top burnei_
should not be oi)erated without cookware on tile
grate. Such abuse could result ill fire and daulage
to your range and will void wmr warranty.
• Do not store or use colnbustible inatelials,
gasoline or other flaniniable wq)ors and liquids
ill tile vicinity of this or any other ai)pliance.
Explosions or fires could result.
• Do not rise ()veil tor a storage area. Items stored in
tile oven can ignite.
• Do not let cooking grease or other flaumlable
ulaterials accuululate in or near the range.
LOCATION
Do not locate the rmage where it may be subject to
strong drafts. Any openings in the floor or wall behind
the rm_ge should be sealed. Make sure the openings
around the base of the range that supply fresh air for
combustion m_d ventilation axe not obstructed by
carpeting or woodwork.
Your range, like nlany other household itelns, is
heavy and can settle into soft floor coverings such as
cushioned vinyl or carpeting. Use care when inoving
tile range on this type of flooring. It is recoumlended
that the following siulple and inexpensive insti uctions
be followed to protect your floor.
Tile range should be installed on a sheet of plywood
(or siulilar niaterial). When the floor covering ends at
the fl'ont of the range, the area that the range will rest
on should be built up with pl)_vood to tile sanie level
or higher than tile floor covering.
This will allow tile range to be uloved tk)i" cleaning
or servicing. Mso, ulake sure your floor covering will
withstand I80°F. (See tile
Installation Safety Instructions
section.)
Make sure tile wall coverings around your range can
withstand tile heat generated (up to 200°F) by tile
ran ,e (See the
Installation Safety Instructions
section.)
IMPORTANT!
Remove all tape mid packaging. Make sure the
burners are properly seated and level.
Take the accessory pack out of the oven mid/or
dra_ve_
Check to be sure that no range parts have come loose
during shipping.
45