Brother MFC 9760 - B/W Laser - All-in-One Service Manual page 207

Selector
No.
1
Not used.
2
Dialing during document reading
3 into the temporary memory in in-
memory message transmission
No. of CNG cycles to be detected
4
(when the line is connected via the
external telephone except in the
5
external TAD mode)
No. of CNG cycles to be detected
6
(when the line is connected via the
external telephone in the external
7
TAD mode)
8 Not used.
NOTE: Selectors 6 and 7 take effect only in the V.34 mode.
Selector 3: Dialing during document reading into the temporary memory in in-memory message
transmission
If this selector is set to "0," the machine waits for document reading into the memory to complete
and then starts dialing. This enables the machine to list the total number of pages in the header of
the facsimile message.
Selectors 4 and 5: No. of CNG cycles to be detected (when the line is connected via the external
The machine interprets a CNG as an effective signal if it detects a CNG signal by the number of
cycles specified by these selectors when the line is connected via the external telephone except in
the external TAD mode.
Selectors 6 and 7: No. of CNG cycles to be detected (when the line is connected via the external
The machine interprets a CNG as an effective signal if it detects a CNG signal by the number of
cycles specified by these selectors when the line is connected via the external telephone in the
external TAD mode.
WSW26
Function
telephone except in the external TAD mode)
telephone in the external TAD mode)
(Function setting 4)
Setting and Specifications
0: Disabled
No. 4 5
0 0 :
0 1 :
1 0 :
1 1 :
No. 4 5
0 0 :
0 1 :
1 0 :
1 1 :
28
1: Enabled
0.5 (A)
1 (B)
1.5 (C)
2 (D)
0.5 (A)
1 (B)
1.5 (C)
2 (D)